All tools

• For use on CNC or conventional lathes with hydraulic contouring equipment
• Machining in a chuck
• Attainable surface finish R_z < 1 micron (R_a = 0.2 micron)

• Machining cylinders with subsequent radius to the plane surface
• Suitable for low and medium strength materials
• Extremely narrow roller

• Machining of cylinders or plane surfaces with subsequent transitional radii of up to 75°
• High roller pressure, suitable for high-strength materials
• Equipped with cantilever roller arrangement

• Tool with cantilever-mounted shaped roller of special design for machining convex and concave shapes by plunge or motion technique
• Equipped with cantilever roller arrangement

• Elimination of microscopic grooves and simultaneous introduction of residual compressive stress
• Short primary processing time
• Elimination of set-up times and downtimes
• No occurrence of dust and slurry
• Only nominal lubrication required (oil or emulsion)
• Roller head guidance without play and low-friction
• Stepless adjustment of roller pressure
• Consistent and controlled machining results through measurement of roller pressure
• Simple replacement of wear parts

• Type EG45 single roller burnishing tools consist of a tool body equipped with a tool shank, a spring assembly that allows the roller head to move with no play and very low friction, and a dial indicator that indirectly measures the burnishing force.
• The roller head is attached to the flexible, spring-loaded section of the tool body.
• EG45-45T and -45F are equipped with floating rollers.
• EG45-40M comes with a smaller roller. Because of its structure, EG45-40M has a lower load capacity.